\n
![\"\"](\"\/product\/EMSolution\/en\/wp-content\/uploads\/quad_tri01.png\")
<\/a>\n<\/p>\n
Fig.1 Analysis model<\/p>\n<\/p><\/div>\n<\/div>\n
Explanation<\/h3>\n
Considering the mesh division for such an analysis, it seems appropriate to use hexahedral elements for the conductors as a structural mesh. In fact, the conductor mesh in Fig. 1 was generated by FEMAP. The conductor mesh is generated by defining the conductor centerline and sweeping the cross-sectional mesh partition along the centerline. It is divided into 10 layers in the direction of the wall thickness. At the same time, the mesh in the air region of the pipe is generated in the same way. it would be difficult for a general-purpose mesh generator to automatically divide such a mesh on a tetrahedron. Also, there is a problem of inaccuracy when eddy current analysis is performed using tetrahedral flat elements.<\/font><\/a> <\/p>\n On the other hand, the space around the conductor needs to be divided into a mesh, which is extremely difficult to divide into a structural mesh with hexahedrons. Rather, we would like to automatically divide the space with tetrahedrons. Fig. 2 shows the mesh division of the outer space of a conductor in FEMAP. Here, the surface elements of the conductor are extracted and transformed into triangles, and the triangulated elements of the air domain boundary are added as the perimeter of the air domain, and the interior is automatically divided into tetrahedral meshes. <\/p>\n Fig.2 Mesh division of air region<\/p>\n<\/p><\/div>\n<\/div>\n As a result, the conductor and the inside of the pipe are divided into hexahedrons, and the outside air area is divided into tetrahedrons. However, as shown in Fig. 3, two triangles are joined to a quadrilateral surface at the element boundaries, creating floating edges, which are handled appropriately to allow for analysis. Here, it is important to note that the nodes are shared. <\/p>\n Fig.3 Joining a hexahedron and a tetrahedron<\/p>\n<\/p><\/div>\n<\/div>\n The results of the analysis based on this model are shown below: Figs. 4 and 5 show the current density in the conductor. Fig.6 shows the distribution of magnetic flux density intensity in the cross section. <\/p>\n
\n <\/a>
\n<\/p>\n
\n <\/a>
\n<\/p>\n